SMC Networks SMC7824M/ESW Manuale Utente Scaricare il pdf (Pagina 46)

NSTALLING

THE

WITCH

3-8

5. If you are sure the module is properly mated with the connector,

tighten the retainer screws to secure the module in the slot.

6. To confirm that the module is correctly installed and ready to use,

connect an active device to the module, and verify that the

corresponding port indicator on the switch’s front panel turns green to

show that there is a valid link.

Installing an Optional SFP Transceiver

Figure 3-6 Inserting an SFP Transceiver into a Slot

This switch supports 1000BASE-SX/LX/ZX SFP-compatible

transceivers. To install an SFP transceiver, do the following:

1. Consider network and cabling requirements to select an appropriate

SFP transceiver type.

2. Insert the transceiver with the optical connector facing outward and

the slot connector facing down. Note that SFP transceivers are keyed

so they can only be installed in one orientation.

3. Slide the SFP transceiver into the slot until it clicks into place.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 103 104

Nessun commento

SMC Networks SMC7824M/ESW Manuale Utente Pagina 46