SMC Networks L2-Lite Manuale Utente Scaricare il pdf (Pagina 169)

100

101

Port Configuration

3-121

- System priority is combined with the switch’s MAC address to form the LAG

identifier. This identifier is used to indicate a specific LAG during LACP

negotiations with other systems.

• Admin Key – The LACP administration key must be set to the same value for ports

that belong to the same LAG. (Range: 0-65535; Default: 1)

• Port Priority – If a link goes down, LACP port priority is used to select a backup

link. (Range: 0-65535; Default: 32768)

Set Port Partner – This menu sets the remote side of an aggregate link; i.e., the

ports on the attached device. The command attributes have the same meaning as

those used for the port actor. However, configuring LACP settings for the partner

only applies to its administrative state, not its operational state, and will only take

effect the next time an aggregate link is established with the partner.

Web – Click Port, LACP, Aggregation Port. Set the System Priority, Admin Key, and

Port Priority for the Port Actor. You can optionally configure these settings for the

Port Partner. (Be aware that these settings only affect the administrative state of the

partner, and will not take effect until the next time an aggregate link is formed with

this device.) After you have completed setting the port LACP parameters, click Apply.

Figure 3-74 LACP Port Configuration

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 613 614

Commenti su questo manuale

Nessun commento

SMC Networks L2-Lite Manuale Utente Pagina 169

Commenti su questo manuale

Prodotti e manuali riguardandi Software SMC Networks L2-Lite